wymiana filtra oleju 2, toyota rav4
[ Pobierz całość w formacie PDF ]
2AZ-FE LUBRICATION
– OIL FILTER
LU–3
OIL FILTER
COMPONENTS
LU
17.2 (175, 13)
OIL FILTER SUB-ASSEMBLY
NO. 1 ENGINE UNDER COVER
N*m (kgf*cm, ft.*lbf)
: Specified torque
A114354E02
ENGINE
2AZ-FE LUBRICATION
LU–4
2AZ-FE LUBRICATION
– OIL FILTER
SST
REPLACEMENT
CAUTION:
• Prolonged and repeated contact with engine oil will
cause the loss of natural oils from the skin, leading to
dryness, irritation and dermatitis. In addition, used
engine oil contains potentially harmful contaminants
which may cause skin cancer.
• Precautions should be taken when replacing engine
oil to minimize the risk of your skin making contact
with used engine oil. Wear protective clothing and
gloves. Wash your skin thoroughly with soap and
water, or use a waterless hand cleaner to remove any
used engine oil. Do not use gasoline, thinners or
solvents.
• For environmental protection, used oil and used oil
filters must be disposed of at designated disposal
sites.
1. REMOVE NO. 1 ENGINE UNDER COVER
2. DRAIN ENGINE OIL
(a) Remove the oil filler cap.
(b) Remove the oil drain plug and drain the oil into a
container.
3. REMOVE OIL FILTER SUB-ASSEMBLY
(a) Using SST, remove the oil filter.
SST 09228-06501
4. INSTALL OIL FILTER SUB-ASSEMBLY
(a) Check and clean the oil filter installation surface.
(b) Apply clean engine oil to the gasket of a new oil
filter.
A112329E01
LU
(c) Lightly screw the oil filter into place by hand. Tighten
it until the gasket contacts the seat.
(d) Using SST, tighten the oil filter.
SST 09228-06501
(1) Depending on the work space available,
choose from the following.
1. If enough space is available, use a torque
wrench to tighten the oil filter.
Torque: 17.2 N*m (175 kgf*cm, 13 ft.*lbf)
2. If enough space is not available to use a
torque wrench, tighten the oil filter a 3/4 turn by
hand or use a common wrench.
5. ADD ENGINE OIL
(a) Clean and install the oil drain plug with a new
gasket.
Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)
SST
A124763E03
2AZ-FE LUBRICATION
– OIL FILTER
LU–5
(b) Add new oil.
Standard capacity
Item
Standard Condition
Drain and refill with oil filter change
4.3 liters (4.5 US qts, 3.8 Imp. qts)
Drain and refill without oil filter
change
4.1 liters (4.3 US qts, 3.6 Imp. qts)
Dry fill
5.0 liters (5.3 US qts, 4.4 Imp. qts)
(c) Install the oil filler cap.
6. CHECK FOR ENGINE OIL LEAKS
7. INSTALL NO. 1 ENGINE UNDER COVER
LU
[ Pobierz całość w formacie PDF ]